Submarine Service Pin

[kandw]

Here is my version of the submarine service pin... This was modeled in Photoshop and illustrator and brought into 3dcut as an stl... I used a 0.0625BN for the carving and a 0.125EM to cut it out... It measures approx. 12inchs across and 4.25 inches tall...

[rsetina]

Very nice work and detail. Thanks for sharing.

[subsea]

Looks great - I always take a small gasp when
I see a set of fish pins.
- Bill

[Bacwudz Kustumz]

Getting better with every cut... lookin good bro.

[VoltsAndBolts]

As a former "Bubble Head" myself, all I can say is SWEET! Nice job!

[David Rueth]

Also as a former Bubble Head I agrea it looks great. It seem we have more than a few pig boat sailer on this form.
I can use the term pig boat because I did my quals on SS487 build in 1947.

[VoltsAndBolts]

@kandw
I don’t won’t to be rude but, would you conceder sharing your STL or gcode?
I would like to scale it down to about 8” across and make a cover for the 2” hitch receiver on my truck.
Rob.

[DDWALKER]

Kandw,

Nice job on the model, it looks great.

David

[kandw]

Thanks everyone...
Sorry but I don't share or sell my models that I use in my business... There is however a model on vectorart that carves very nice... I used it in the past.

http://www.vectorart3d.com/store/index. ... l&ID=57254

[VoltsAndBolts]

No need to be sorry, I completely understand.