First Project in Cut 3D
- sunshinejim
- Vectric Craftsman
- Posts: 172
- Joined: Sat Mar 03, 2007 11:07 pm
- Location: Windsor, Ontario, Canada
First Project in Cut 3D
This is my first attempt at working with Cut 3D. It is cut in a piece of cherry with light cherry stain to highlight the logo and the frame.
Re: First Project in Cut 3D
That came out nice. Did you make the model?
- sunshinejim
- Vectric Craftsman
- Posts: 172
- Joined: Sat Mar 03, 2007 11:07 pm
- Location: Windsor, Ontario, Canada
Computers and especially the CNC are something new to me. I have done woodworking all my life but nothing like this. Have to give Vectric and Cut 3D all the credit - all I did was follow the instructions (also something new for me)
The plaque is 8"wide x 9 1/2" high. Did roughing cut with 1/8" flat end mill and finish with 1/8" ball end mill.
I used a Dremel with a ball nose bit to remove any cut marks and to random texture the background.
Finished with 3 coats of spray laquer.
Artwork is from Vector Clip 3D.
Looking forward to lots more - big learning curve for me.
The plaque is 8"wide x 9 1/2" high. Did roughing cut with 1/8" flat end mill and finish with 1/8" ball end mill.
I used a Dremel with a ball nose bit to remove any cut marks and to random texture the background.
Finished with 3 coats of spray laquer.
Artwork is from Vector Clip 3D.
Looking forward to lots more - big learning curve for me.