Hello All,
Here is a model I cut last nite.
It took about 6 hours.
It is done in some Freeman green foam sample that I had.
I would rather do it in wax, then cast it!
At this size...
The model was done in AC3D.
Hope you all like it!
Vectric software is one of the best!
Grease
One of my firsts
- Greasetattoo
- Vectric Wizard
- Posts: 854
- Joined: Sat Mar 24, 2007 3:14 pm
- Location: Saint Paul, Minnesota
- Contact:
- Greasetattoo
- Vectric Wizard
- Posts: 854
- Joined: Sat Mar 24, 2007 3:14 pm
- Location: Saint Paul, Minnesota
- Contact: