Cut this using the trial version of CUT3d. had to port it over to Vcarve pro because the output file from Cut3d gave a 'Line error' when opened in Mach3. Very strange because the output from Vacarve pro to Mach3 was fine.
I found that the 'cutout' path was not as good as I would have liked it. I stepped down 2mm at a time using a 4mm end mill to a depth of 20.5mm. Should I have done a profile pass after the cut out path.
Many thanks
George
Trial version Leaf design
- Len-Tikular
- Vectric Wizard
- Posts: 415
- Joined: Sat Feb 13, 2010 11:27 am
- Model of CNC Machine: Home made revision 3
- Location: Denholm Scotland.
Trial version Leaf design
Len-Tikular (A glider pilots dream cloud)
Aspire 10.5
Mach4 Hobby
Ess Smoothstepper + C11g+C10s
Aspire 10.5
Mach4 Hobby
Ess Smoothstepper + C11g+C10s