I have the full version of Cut2D and would like to try out Cut3D.
I have imported some .stl files into the Cut3D trial version and can set everything up ok until I come to save the toolpaths. (As I only have the trial version i can't go any further.)
I would like to know, if i purchased the full version, would I be able to save my file and import it into Cut2D ?. I have tried saving the example files but when I try to open them in Cut2D I get an error message saying that there are no available toolpaths saved with the file. (screen dump attached)
Also another question. In Cut2D my Post Processor is Grbl (mm) (*.gcode). This option is not shown in Cut3D . Is this just because it is a trial version?