need some help
need some help
this is the tool I have trying to figure out the right setting the setting came from there web site but it doesn't look right to me using aspire 9.5 thank you for your help
-
- Vectric Wizard
- Posts: 1592
- Joined: Sun Sep 16, 2007 2:59 pm
- Model of CNC Machine: Custom DIY
- Location: Lake St Clair, MI, USA
- Contact:
Re: need some help
I answered your post on CNC Zone yesterday.
Diameter = 0.25
Tip Radius = 0.0625
Diameter = 0.25
Tip Radius = 0.0625
Gerry - http://www.thecncwoodworker.com
Re: need some help
ok thank you didn't see it should the step over and the and clearance pass be the same about the same 5% 10%
-
- Vectric Wizard
- Posts: 1592
- Joined: Sun Sep 16, 2007 2:59 pm
- Model of CNC Machine: Custom DIY
- Location: Lake St Clair, MI, USA
- Contact:
Re: need some help
Most people use 6%-10%, depending on the project, how fast you want it to cut, and what you want the finished look to look like. It's a matter of personal preference.
But you'll definitely want it higher than 1.2%.
The Clearance setting is fine.
But you'll definitely want it higher than 1.2%.
The Clearance setting is fine.
Gerry - http://www.thecncwoodworker.com