good1 wrote:I am useing a 3D gorilla clipart from vectric for a 6x7 box top. After previewing cutting the rough cut with a .25 end mill. I set my finish cut at .04 below the survace for the finish cut. When I preview the finish toolpath it is not smoth like the model. Will it cut like the preview or will it carve smooth like the model. I am useing a .125 ballnose bit with a 7% stepover. I really do not want to start cutting, it is over a 2hour carve time. Thanks for any info... Gene
Bob Reda wrote:It should look like the preview. Your settings look good, can you post the file?
good1 wrote:The gorilla model came with vcarve 8.5
Users browsing this forum: No registered users and 8 guests