3d post processor

This forum is for general discussion about Cut3D
Post Reply
Win Brayer
Posts: 44
Joined: Sun Jan 06, 2013 11:16 pm
Model of CNC Machine: Mako CNC Shark HD

3d post processor

Post by Win Brayer »

What post processor do I select?

Savannahdan
Vectric Wizard
Posts: 520
Joined: Sun May 03, 2015 12:25 pm
Model of CNC Machine: Axiom AR8
Location: Savannah, GA

Re: 3d post processor

Post by Savannahdan »

I have my Shark HD set at CNCShark-USB Arcs(inch) for Aspire and CNCShark-USB(inch) for Cut3D.

jhva
Posts: 2
Joined: Fri Aug 07, 2015 5:33 pm
Model of CNC Machine: Probotix Meteor
Location: New Kent, VA USA (Lanexa area)

Re: 3d post processor

Post by jhva »

Do I use the same post processor as in Cut 2d? I use EMC2-G64 Arcs (inch) for Cut 2d

Post Reply