Hi
It's been a year since I've run anything using Cut3d... I've gotten older and forgetful.. argh
Which post processor do I need to save my tap files as from Cut3d ?
1) cnc shark USB 3d contour (inch)
2) cnc shark USB (inch)
3) cnc shark USB arcs (inch)
I think it's 3D contour,.. but I am not positive about that (shrug)
Thank you for your help
DougE
CNC Shark pro-- what post processor to use
-
- Vectric Craftsman
- Posts: 233
- Joined: Mon Dec 31, 2012 7:35 pm
- Model of CNC Machine: Shark Pro Plus HD & Custom built 4x4
- Location: Ohio
Re: CNC Shark pro-- what post processor to use
It's been a couple of years since I've even turned mine on but I believe it should be number (3) cnc shark USB arcs (inch)
- Ms Wolffie
- Vectric Wizard
- Posts: 2695
- Joined: Sat Mar 31, 2012 10:41 pm
- Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
- Location: Tully Heads, Wet Tropics, Queensland, Australia
Re: CNC Shark pro-- what post processor to use
Your memory is spot on coconut
Cheers
Wolffie
Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6
Wolffie
Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6
Re: CNC Shark pro-- what post processor to use
I saved and ran with;
cnc shark USB 3d contour (inch)
The shark didn't seem to have any issue with this post processor.
I guess I'll run a test with the 'arc' processor and see if there is any problem with it.
Thank you
DougE
cnc shark USB 3d contour (inch)
The shark didn't seem to have any issue with this post processor.
I guess I'll run a test with the 'arc' processor and see if there is any problem with it.
Thank you
DougE