CNC Shark pro-- what post processor to use

This forum is for general discussion about Cut3D
Post Reply
DougE
Posts: 18
Joined: Thu Jan 01, 2015 7:01 pm
Model of CNC Machine: cnc Shark- -other

CNC Shark pro-- what post processor to use

Post by DougE »

Hi

It's been a year since I've run anything using Cut3d... I've gotten older and forgetful.. argh

Which post processor do I need to save my tap files as from Cut3d ?

1) cnc shark USB 3d contour (inch)
2) cnc shark USB (inch)
3) cnc shark USB arcs (inch)

I think it's 3D contour,.. but I am not positive about that (shrug)

Thank you for your help

DougE

ohiococonut
Vectric Craftsman
Posts: 233
Joined: Mon Dec 31, 2012 7:35 pm
Model of CNC Machine: Shark Pro Plus HD & Custom built 4x4
Location: Ohio

Re: CNC Shark pro-- what post processor to use

Post by ohiococonut »

It's been a couple of years since I've even turned mine on but I believe it should be number (3) cnc shark USB arcs (inch)

User avatar
Ms Wolffie
Vectric Wizard
Posts: 2695
Joined: Sat Mar 31, 2012 10:41 pm
Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
Location: Tully Heads, Wet Tropics, Queensland, Australia

Re: CNC Shark pro-- what post processor to use

Post by Ms Wolffie »

Your memory is spot on coconut
Cheers
Wolffie

Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6

DougE
Posts: 18
Joined: Thu Jan 01, 2015 7:01 pm
Model of CNC Machine: cnc Shark- -other

Re: CNC Shark pro-- what post processor to use

Post by DougE »

I saved and ran with;
cnc shark USB 3d contour (inch)

The shark didn't seem to have any issue with this post processor.
I guess I'll run a test with the 'arc' processor and see if there is any problem with it.

Thank you

DougE

Post Reply