Post Processor

This forum is for general discussion about Cut3D
Post Reply
JMD
Vectric Craftsman
Posts: 197
Joined: Sun Apr 03, 2011 3:07 pm
Model of CNC Machine: Probotix GX2525 with rotary
Location: Erie, PA

Post Processor

Post by JMD »

Put new computer in shop. Trying to install CNC Shark Post Processor -USB version - CNCSHARK - USB - NEWARCS _ INCH VCARVE, ASPIRE AND CUT 3D.
Followed instructions on web-page. Down loaded and saved. Copied to Cut 3D PostP. It is listed. Dose not show up when I try to save Tool Path. Must be something I an doing, but can not figure out what. HELP. :?
Thank you,
John Douglass
douglassjohn2@gmail.com

JMD
Vectric Craftsman
Posts: 197
Joined: Sun Apr 03, 2011 3:07 pm
Model of CNC Machine: Probotix GX2525 with rotary
Location: Erie, PA

Re: Post Processor

Post by JMD »

Got it !! :D Thanks

Post Reply