bottom to back

This forum is for general discussion about Cut3D
Post Reply
mwhatch
Vectric Apprentice
Posts: 53
Joined: Sat Apr 24, 2010 1:07 pm
Location: Oklahoma

bottom to back

Post by mwhatch »

I have a model of a statue that I would like to carve 4 sided, but I need to make the front and back to the top and bottom so it will actually carve the front, back left, right.

Is this clear as mud?

Thanks
Morton

Zenbot 12X16, DesighCad 3d, PhotoVcarve, Cut3D, Aspire

mwhatch
Vectric Apprentice
Posts: 53
Joined: Sat Apr 24, 2010 1:07 pm
Location: Oklahoma

Re: bottom to back

Post by mwhatch »

Ok, i figured it out. Make left or right the top surface.

Seems to work in preview. Now just need to make a jid to hold for 4 sided cut.

Morton
Morton

Zenbot 12X16, DesighCad 3d, PhotoVcarve, Cut3D, Aspire

Post Reply