Cutout problem....

[Normsthename]

I have been busy using Cut3D since getting the full version, and I have found another minor annoyance.
A part I was creating tapered down on all the edges, and when the cutout is created it machines the whole depth of the material, 95 % of this machining time was a complete waste of time because on the part I did only needed the bottom 2-3mm of material to be cut out.
I would think a starting depth option on the cutout menu (See attached mockup....) would be nice

Thanks

Andy

[Tony Mac]

Hi Andy,

Good idea and one for the enhancement list.

Thanks,
Tony