I have been making cribbage boards by hand for the last couple of years.. recently I purchased a cnc shark pro
and am just getting my feet wet. I learned to play cribbage over 50 years ago and do so enjoy it.i am wondering if anyone uses a certain program or how do you get the hole pattern right and what size drill is used. I have read that some people use
vector art 3d and Some use Vcarve Pro.. The boards shown here are beautiful. Since we are retired I would like to make some that look like our RV does anyone have any hints of short cuts that would help.. Looking for some advice and help.
Tom
Cribbage board help
Moderator: Todd Bailey
-
- Posts: 40
- Joined: Thu Sep 17, 2009 11:47 pm
- Model of CNC Machine: CNC Shark Pro
- Location: GRAND RAPIDS, MI
- Contact:
-
- Vectric Wizard
- Posts: 4797
- Joined: Thu May 18, 2006 3:24 pm
- Model of CNC Machine: ShopBot
- Location: North Carolina
Re: Cribbage board help
Tom,
If you search the forum (see menu near top of page) you can find a lot of info. But perhaps the best thread for you to read is here where LT985 shares his technique:
http://www.vectric.com/forum/viewtopic.php?f=29&t=4844
Tim
If you search the forum (see menu near top of page) you can find a lot of info. But perhaps the best thread for you to read is here where LT985 shares his technique:
http://www.vectric.com/forum/viewtopic.php?f=29&t=4844
Tim