Cribbage board help

[Tmswoodshop]

I have been making cribbage boards by hand for the last couple of years.. recently I purchased a cnc shark pro
and am just getting my feet wet. I learned to play cribbage over 50 years ago and do so enjoy it.i am wondering if anyone uses a certain program or how do you get the hole pattern right and what size drill is used. I have read that some people use
vector art 3d and Some use Vcarve Pro.. The boards shown here are beautiful. Since we are retired I would like to make some that look like our RV does anyone have any hints of short cuts that would help.. Looking for some advice and help.
Tom

[tmerrill]

Tom,

If you search the forum (see menu near top of page) you can find a lot of info. But perhaps the best thread for you to read is here where LT985 shares his technique:

http://www.vectric.com/forum/viewtopic.php?f=29&t=4844

Tim