Warrior

Post by **Rcnewcomb** » Sat Jun 28, 2008 4:11 pm

9"x9"
rough: 0.250" downspiral at 2.0/1.0 at 16K RPM (20 minutes)
finish: 0.125 ballnose at 3.0/2.0 at 16K RPM (80 minutes)

The face detail is better than shown in the photo. Note the detail on the bow string.

This is hard maple. I will finish this with a pecan glaze and satin lacquer.

I have also modeled this at 24x24 and it is absolutely stunning so I may carve this at that size.

Post by **Rcnewcomb** » Sat Jul 05, 2008 12:06 am

Part-way through the glazing process.

I used two different shades of glaze on this - golden pecan and cabernet

Post by **Rcnewcomb** » Tue Jul 08, 2008 4:41 am

After a bit more cleanup

Post by **zafirus** » Wed Mar 04, 2009 8:19 pm

Hello!wonderful works! best regards Tibor

Post by **Thkoutsidthebox** » Wed Mar 04, 2009 8:49 pm

The detail really is amazing. I can't believe you only used a 1/8 inch bit and its so clear. Nice work.

Post by **maloneyandco** » Wed Mar 04, 2009 9:32 pm

You do some really nice stuff.
Thanks for sharing
Rob

Post by **Rcnewcomb** » Wed Mar 04, 2009 10:44 pm

I can't believe you only used a 1/8 inch bit and its so clear

I think this speaks well of the quality of designs by James Booth and the other artists showcased on VectorArt3D. They come up with files that are both beautiful AND machinable.

Vectric Customer

Warrior

Warrior

Re: Warrior

Re: Warrior

Re: Warrior

Re: Warrior