Hi All , fairly new to CNC , did these in 3D Machinist and imported to V-Carve Pro , cut out of 3/4 maple , shellac and glaze , milk paint , and lacquer finish , I am pleased with them for my first attempts , I have since upgraded to Aspire so will be using that from here on out
Frames with 3D Machinist & V-Carve Pro
Moderator: Todd Bailey
-
- Posts: 17
- Joined: Fri Oct 25, 2013 3:08 pm
- Model of CNC Machine: CAMaster Stinger I WinCNC Aspire 8
- scottp55
- Vectric Wizard
- Posts: 4717
- Joined: Thu May 09, 2013 11:30 am
- Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP11.5
- Location: Kennebunkport, Maine, US
Re: Frames with 3D Machinist & V-Carve Pro
If that's you're First attempt, Don't show your hundredth!
You'll make us Look bad
Congrats!!
scott
You'll make us Look bad
Congrats!!
scott
I've learned my lesson well. You can't please everyone,so you have to please yourself
R.N.
R.N.
-
- Posts: 17
- Joined: Fri Oct 25, 2013 3:08 pm
- Model of CNC Machine: CAMaster Stinger I WinCNC Aspire 8
Re: Frames with 3D Machinist & V-Carve Pro
scottp55 wrote:If that's you're First attempt, Don't show your hundredth!
You'll make us Look bad
Congrats!!
scott
Ha , thanks Scott , very nice of you . I read and lurk a lot on these forums , try to soak up as much as I can . Just trying to emulate what some of the talented guys/gals have shared here