Frames with 3D Machinist & V-Carve Pro

Gallery for samples created from Design and Make 3D Machinist or using Design & Make projects

Moderator: Todd Bailey

Post Reply
adirondak5
Posts: 17
Joined: Fri Oct 25, 2013 3:08 pm
Model of CNC Machine: CAMaster Stinger I WinCNC Aspire 8

Frames with 3D Machinist & V-Carve Pro

Post by adirondak5 »

Hi All , fairly new to CNC , did these in 3D Machinist and imported to V-Carve Pro , cut out of 3/4 maple , shellac and glaze , milk paint , and lacquer finish , I am pleased with them for my first attempts , I have since upgraded to Aspire so will be using that from here on out :)

Image

User avatar
scottp55
Vectric Wizard
Posts: 4713
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP11.5
Location: Kennebunkport, Maine, US

Re: Frames with 3D Machinist & V-Carve Pro

Post by scottp55 »

If that's you're First attempt, Don't show your hundredth!
You'll make us Look bad :)
Congrats!!
scott
I've learned my lesson well. You can't please everyone,so you have to please yourself
R.N.

adirondak5
Posts: 17
Joined: Fri Oct 25, 2013 3:08 pm
Model of CNC Machine: CAMaster Stinger I WinCNC Aspire 8

Re: Frames with 3D Machinist & V-Carve Pro

Post by adirondak5 »

scottp55 wrote:If that's you're First attempt, Don't show your hundredth!
You'll make us Look bad :)
Congrats!!
scott

Ha , thanks Scott , very nice of you . I read and lurk a lot on these forums , try to soak up as much as I can . Just trying to emulate what some of the talented guys/gals have shared here

Post Reply