First time cutting with zebra wood, I have stayed clear due to the expense.
Found a 5ft chunk too good to pass up ... Only 5" wide, but thats perfect for this mask design.
Its about 12x4". .80 thick.
Did a rough pass with a .25 endmill, then a finish with a .9 ballnose. Didn't do a complete cutout, as lately I like leaving the objects in the wood block ,,, But I did cut the outline down to about .70. That not only cleans up the rough cutting outline, but emphasizes its 3D character as well. Used 2 coats of spray on gloss clear coat, put a hanger on it, and thats it.
Total time from block of wood to this was about 2 hours.