I love 3D Machinist

[nostradamus]

This is a carving I did a few weeks ago. It is on a decorative canoe paddle. I'm very happy that I have the ability to offer 3D carving while I'm saving my pennies for Cut 3D and then eventually Aspire. Thank you Vectorart 3D and Vectric!

Nos

[tmerrill]

Nos,

That looks great!

Take that to some area craft shops, boat places, marina's, tackle shops or whatever you have in your area. It just may generate some interest and a little extra income will help toward Cut3D and Aspire.

Tim

[nostradamus]

Thanks Tim,
That means alot coming from you. You'll notice a mean attempt at your glazing technique. Thank you for putting that PDF together. I was very happy with how this turned out. It is my third attempt at 3D. The first two were a little disappointing, so I was stoked when this one turned out so well. It is about 5 1/2" x 9" and it only took about 10 min. of clean-up (sanding and smoothing) before it was ready for finish.
I would love to take this to some shops, however, I did this for a friend (He cut out and shaped the paddle) so he has it now.
Thanks,
Nos

[buck4]

Nos,
That looks great, and nice job with the glaze. I been wanting to try it, someday.
Hang in there, warmer days are coming............Buck

[GripUs]

Nos...nicely done!

Joe

[JamesB]

Nos, excellent work, thanks for sharing. Would it be OK to add this to our gallery on the site please?

Thanks,
James

[nostradamus]

Thanks for the encouragement guys!

James, of course you can do whatever you want with it! I'm honored.

Nos